Sidebar

Filter

Adjustable angle of attack

Adjustable dual squeegee pressure/speed

Adjusts to various size frames

Annual Duty Cycle

Approx Warm-up Time

Blow-thru Air Nozzle

Compressed Air Required

Consumption (Nitrogen)

Conveyor Extensions

Cooling Station(s)

Cooling Zone Venting

CyclonicsTM (forced air)

Dispenser Option

Display Technology

Fine Pitch Capability

Foam Fluxer Tank

Heat Tunnel Length

Largest Component Size

Laser Centering

Linear squeegee guide

Matrix Tray Feeders

Max Board Height

Max Board Width

Max Conveyor Speed

Max No. of Feeders (8 mm Tape)

Max No. of Feeders with L-GB-12 Bank Feeders

Max Placement Rate

Max Preheat 1 Temp

Max Preheat 3 Temp

Max Solder Temp

Max Temperature

Max Temperature

Max Travel Area

Max Wave Height

Maximum Print Area

Min. Neighbor Component Clearance

Nitrogen Option

Operating system

Overall Dimensions

Overall Dimensions

Overall Dimensions

Placement Accuracy

Preheat 1 Power

Preheat 2 Power

Preheat 3 Power

Pressure (Nitrogen)

Processing Speeds

Smallest Component Capability

Solder Capacity

Solder Capacity

Solder Pot and Pump

Solder Pot Capacity

Solder Pot Power

Temperature Range (standard model)

Typical Verifiable Placement Rate

Vacuum hold-down option

Vibratory Feeders

Automated Systems

Manual Systems

Manual Systems

MPP-21 Pick and Place System

MPP-21 Pick and Place System

Efficient and accurate manual pick & place with dispenser designed for low volume prototype and medium volume production runs.

Notify me Add to Wish List Add to Compare

MPP-11 Manual Desktop Pick and Place Machine

MPP-11 Manual Desktop Pick and Place Machine

Cost effective manual pick & place and dispenser system for short run and prototype assembly of printed circuit boards.

Notify me Add to Wish List Add to Compare